AeroGCS Config
  • 1. AeroGCS Config
  • 2. Firmware Flashing Procedure
  • 3. New Drone Configuration System
    • 3.1 Setting up your AeroGCS Config
    • 3.2 Using AeroGCS Config
      • 3.2.1 Signing in
      • 3.2.2 Establishing Drone Connection for Configuration
      • 3.2.3 RPA Configurations
        • 3.2.3.1 Choosing Airframes
        • 3.2.3.2 Sensor Calibration
        • 3.2.3.3 Safety Settings
        • 3.2.3.4 Assigning Flight Mode
        • 3.2.3.5 RC Calibration
        • 3.2.3.6 Motor and ESC Calibration
        • 3.2.3.7 Power Settings
        • 3.2.3.8 Serial Parameter Settings
        • 3.2.3.9 Camera and Camera Config
      • 3.2.4 Spraying Configurations
      • 3.2.5 Reset Parameters
      • 3.2.6 Advanced Settings
      • 3.2.7. Firmware Upgrade
      • 3.2.8. Log Analyzer
      • 3.2.9 Drone Details
Powered by GitBook
On this page
  1. 3. New Drone Configuration System
  2. 3.2 Using AeroGCS Config

3.2.9 Drone Details

Drone details at your fingertips."

3.2.9 Drone Details

This section of the AeroGCS Config displays drone details, including.

  1. Drone ID and

  2. Firmware version,

as shown in the following screen.

Drone Details

This concludes all the sections of the AeroGCS Config.

Previous3.2.8. Log Analyzer

Last updated 1 year ago